Reply to thread

Message

<blockquote data-quote="McPaulie9292" data-source="post: 3578084" data-attributes="member: 73070">Thanks alot for the help guys .... But it got rescheduled for this morning, and I just passed by a few points, supervisor was very lenient since Im unfamiliar with the sequence of operations UPS uses and that im young and teachable, so all is well.... got the interview with HR on Tuesday and a piss test, than could possibly start the day after .. Ill do the world a favor, for whoever googles this test1. Identifying parts laying on table mostly used on conveyor system and elec controls2. Measure and cut conveyor belt using step by step instructions provided (supv will check measurements after and grade) 3. Change and adjust 2 sprockets and chain off motor under conveyor system .. answer series of questions about how to perform certain maintenance tasks on conveyor after.4. Describe electrical components in “bucket” which is essentially a disconnect box with HV fuses, motor starter, OL protection, transformer, etc .. than troubleshoot and find issues with said “buckets”.5. Wire up 3 phase 480v motor 6. Weld &amp; use cutting torchDont ever say I never did anything for ya</blockquote>

[QUOTE="McPaulie9292, post: 3578084, member: 73070"] Thanks alot for the help guys .... But it got rescheduled for this morning, and I just passed by a few points, supervisor was very lenient since Im unfamiliar with the sequence of operations UPS uses and that im young and teachable, so all is well.... got the interview with HR on Tuesday and a piss test, than could possibly start the day after .. Ill do the world a favor, for whoever googles this test 1. Identifying parts laying on table mostly used on conveyor system and elec controls 2. Measure and cut conveyor belt using step by step instructions provided (supv will check measurements after and grade) 3. Change and adjust 2 sprockets and chain off motor under conveyor system .. answer series of questions about how to perform certain maintenance tasks on conveyor after. 4. Describe electrical components in “bucket” which is essentially a disconnect box with HV fuses, motor starter, OL protection, transformer, etc .. than troubleshoot and find issues with said “buckets”. 5. Wire up 3 phase 480v motor 6. Weld & use cutting torch Dont ever say I never did anything for ya [/QUOTE]

Verification