Home
Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Home
Forums
Brown Cafe UPS Forum
Life After Brown
Motor for canoe
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="over9five" data-source="post: 540528" data-attributes="member: 1401"><p>Darn, I was not done with that post!</p><p> </p><p>3/8" carriage bolts hold the two 2x2 pieces of oak together with washers, lock washers, and wing nuts.</p><p> </p><p>I cheaped out on the 2x4 that the motor clamps to. I wanted oak here too, but Home Depot only had 8 footers. Too expensive when I only needed 8 inches! 5 1/2" lag screws hold a PT pine 2x4 (that I had in the garage) to the 2x2.</p><p>If anyone has a 2x4 piece of oak or ash, send it over!</p></blockquote><p></p>
[QUOTE="over9five, post: 540528, member: 1401"] Darn, I was not done with that post! 3/8" carriage bolts hold the two 2x2 pieces of oak together with washers, lock washers, and wing nuts. I cheaped out on the 2x4 that the motor clamps to. I wanted oak here too, but Home Depot only had 8 footers. Too expensive when I only needed 8 inches! 5 1/2" lag screws hold a PT pine 2x4 (that I had in the garage) to the 2x2. If anyone has a 2x4 piece of oak or ash, send it over! [/QUOTE]
Insert quotes…
Verification
Post reply
Home
Forums
Brown Cafe UPS Forum
Life After Brown
Motor for canoe
Top