Home
Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Home
Forums
Brown Cafe UPS Forum
UPS Discussions
DIAD question
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="T-Bone" data-source="post: 817347" data-attributes="member: 18255"><p>I run a route at a mall where there are dozens of consignees. Each consignee is shown as a stop in my diad. However, all the consignees have the same address so my diad has many screens filled with the single mall address. To see what each line represents I have to select it and press the "details" soft-key. On two occasions over the last few months (once on a diad III and once on a IV), I pressed the scan button to wake it back up and lo-and-behold the consignees are listed where the street address was! If I could have it like that all the time it would make things much easier obviously. So, the big question is: how do I switch it from street display to consignee? Let me add that stops without any consignee assigned to them still show the street address. No one in my center has a clue.</p></blockquote><p></p>
[QUOTE="T-Bone, post: 817347, member: 18255"] I run a route at a mall where there are dozens of consignees. Each consignee is shown as a stop in my diad. However, all the consignees have the same address so my diad has many screens filled with the single mall address. To see what each line represents I have to select it and press the "details" soft-key. On two occasions over the last few months (once on a diad III and once on a IV), I pressed the scan button to wake it back up and lo-and-behold the consignees are listed where the street address was! If I could have it like that all the time it would make things much easier obviously. So, the big question is: how do I switch it from street display to consignee? Let me add that stops without any consignee assigned to them still show the street address. No one in my center has a clue. [/QUOTE]
Insert quotes…
Verification
Post reply
Home
Forums
Brown Cafe UPS Forum
UPS Discussions
DIAD question
Top