If you're doing a Driver Release for a non-apartment, you press the scan button then you scan the barcode. The stop will then come up in the DIAD. Then you press the "big down" button. At the bottom of the screen, you will see different options, with corresponding buttons under them. You press the button that is for "Deliver". Then you select your delivery location. Typically it will be Porch, which is 6. Then you press the "Stop Complete" button and you're done. The driver can point out to you which buttons are the ones I just named.
If you're delivering to an apartment, you first scan the package. Automatically, on the next screen, the "cursor" will be in the "Room" field. You type the apartment number there and hit the "Enter" button. Then you can type in the floor number. Press "big down". You will press the signature button, then you will press Enter again to enter the signature screen. When the customer has signed for the package, you will press signature again and it will take you to the "Clarify" field. You type in the last name of the person who received the package from you. You will have to ask them for this name, as you can almost never read what they signed. At this point I can't remember if you hit Enter or press the Signature button to get out of the signature screen. Once you're out, you press Stop Complete. It will prompt you specify whether it was a Residential or Commercial stop. 1 for Res, 2 for Com.
If an apartment customer is not home and the complex does not accept customer packages:
1) Scan package
2) Enter apt number
3) Enter Floor
4) big down
5) scan infonotice (fill out the infonotice)
6) Select "NonDel"
7) Press 4 for "Not In"
8) Select the proper delivery attempt number (1, 2, or 3)
9) Stop Complete
10) 1 for Res
Hopefully I didn't mess up on any of these instructions.