curiousbrain
Well-Known Member
I've been asked to try and setup a UPS application of some sort which can iterate over the scan checks that have been performed thus far on a particular day, and will report any misloads. I'm pretty computer savvy, but was informed that one or two people tried to set up this application before and could not get it to work.
Also, I have no idea what the name of this application is, or what kind of network resources it might need access to (as an example: the Preload Assist Server) ... because I am not an IT person (and/or have no access to documentation about this application), I'm not sure if discovery is automatic over the network or not (i.e. does PAS have a specific network address, to follow on the previous example).
If any one could provide any insight into this application, and what information might be required to configure it properly, that would be much appreciated.
Also, I have no idea what the name of this application is, or what kind of network resources it might need access to (as an example: the Preload Assist Server) ... because I am not an IT person (and/or have no access to documentation about this application), I'm not sure if discovery is automatic over the network or not (i.e. does PAS have a specific network address, to follow on the previous example).
If any one could provide any insight into this application, and what information might be required to configure it properly, that would be much appreciated.