I run a route at a mall where there are dozens of consignees. Each consignee is shown as a stop in my diad. However, all the consignees have the same address so my diad has many screens filled with the single mall address. To see what each line represents I have to select it and press the "details" soft-key. On two occasions over the last few months (once on a diad III and once on a IV), I pressed the scan button to wake it back up and lo-and-behold the consignees are listed where the street address was! If I could have it like that all the time it would make things much easier obviously. So, the big question is: how do I switch it from street display to consignee? Let me add that stops without any consignee assigned to them still show the street address. No one in my center has a clue.