As far as smooth car routine it may vary from area to area but essentially it goes push fob when safe to enter car, put diad in left hand, right hand to handrail, step up stairs with 3 points of contact putting diad in holder while moving past it hit starter button while moving past it once and put on seat belt and step on clutch and brake then push engine start button again. 123 count is clutch gear hand brake in that order. Check mirrors and camera,Turn off flashers, signal when pulling from curb...
When dismounting flashers on if not already, engage handbrake, put in lowest forward facing gear, kill engine with button, push button again to open bulkhead, select package, close bulkhead door, set package down grab diad, use handrail to exit while clearing ground below and both directions. Once out grab package in power zone...
I'm just typing this quickly and probably forgetting things so make sure you pay attention in training.