By Invitation Only

UpstateNYUPSer(Ret)

Well-Known Member
Electrical work you can do yourself but it still has to be checked by a licensed electrician and get inspected. You can still save money by doing most of the work yourself. Most plumbing is more lenient on the codes unless you have major work done. Then it has to be brought up to current codes and inspected. And there has been a ton of new things added to the codes in recent years.

When my water heater went out I called a local plumbing company to install a new one. No permit required.
 

UpstateNYUPSer(Ret)

Well-Known Member
Easy to do yourself. Still a pain in the butt.

Much easier to have it done while you are at work and write a check while on break.

One guy did the job by himself----even carried (hand cart) the heater out of the basement himself.

It sucks that the only way that you know you water heater is shot is when you are trying to take a shower before going to work.
 

oldngray

nowhere special
When my water heater went out I called a local plumbing company to install a new one. No permit required.
You didn't used to need a permit for a water heater here but that changed mostly as another source of revenue for the government. You can bypass that if you do the work yourself but if you hire a professional then you do need a permit.
 

oldngray

nowhere special
Much easier to have it done while you are at work and write a check while on break.

One guy did the job by himself----even carried (hand cart) the heater out of the basement himself.

It sucks that the only way that you know you water heater is shot is when you are trying to take a shower before going to work.

I replaced mine by myself and getting it out of the basement wasn't easy. It didn't go bad suddenly. It started to get a slow leak at the drain spigot at the bottom. Those can be replaced but the water heater was old and not worth trying to repair. As long as you get a new one the same size and the connections line up its not very hard. Although my old one was soldered in to the copper pipes so I had to cut it out. I then put in threaded connections so it will be much easier next time.
 

UpstateNYUPSer(Ret)

Well-Known Member
I replaced mine by myself and getting it out of the basement wasn't easy. It didn't go bad suddenly. It started to get a slow leak at the drain spigot at the bottom. Those can be replaced but the water heater was old and not worth trying to repair. As long as you get a new one the same size and the connections line up its not very hard. Although my old one was soldered in to the copper pipes so I had to cut it out. I then put in threaded connections so it will be much easier next time.

He had a hell of a time breaking the connections----said they were badly calcified.
 
Top